blob: eae516912eda6f69b7b3f45b193f9bbcd257159c (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
|
############################# Parallel Ports ##############################################
# Load Driver for Two Parallel Ports, one for Breakout Board, other for Plasma Torch Height Control
loadrt hal_parport cfg="0xa400 0xac00"
# Connect both Paralell Ports to Threads for Read / Write
addf parport.0.read base-thread 1
addf parport.0.write base-thread -1
addf parport.1.read base-thread 1
addf parport.1.write base-thread -1
# Invert pins to make motors move in right direction
setp parport.0.pin-06-out-invert 1
setp parport.0.pin-07-out-invert 1
# Hook up the step and dir signals to the parport pins
# Axis A and Y are the same axis but different motors
net StepX stepgen.0.step => parport.0.pin-02-out
net StepY stepgen.1.step => parport.0.pin-03-out
net StepZ stepgen.2.step => parport.0.pin-04-out
net StepA stepgen.3.step => parport.0.pin-05-out
net DirX stepgen.0.dir => parport.0.pin-06-out
net DirY stepgen.1.dir => parport.0.pin-07-out
net DirZ stepgen.2.dir => parport.0.pin-08-out
net DirA stepgen.3.dir => parport.0.pin-09-out
# Hook up limit and home switches, each axis shares a common pin for homing, limit min and limit max
net LimitX parport.0.pin-11-in-not => axis.0.neg-lim-sw-in axis.0.pos-lim-sw-in axis.0.home-sw-in
net LimitY parport.0.pin-12-in-not => axis.1.neg-lim-sw-in axis.1.pos-lim-sw-in axis.1.home-sw-in
net LimitZ parport.0.pin-13-in => axis.2.neg-lim-sw-in axis.2.pos-lim-sw-in axis.2.home-sw-in
net LimitA parport.0.pin-15-in-not => axis.3.neg-lim-sw-in axis.3.pos-lim-sw-in axis.3.home-sw-in
# Hook up the spindle signal
net SpindleOn motion.spindle-forward => parport.1.pin-01-out
|
